High performance water reducing agent XNHPWA-600高性能减水剂

Products > High performance water reducing agent XNHPWA-600高性能减水剂

High performance water reducing agent XNHPWA-600高性能减水剂

 Product introduction  产品简介  

     XNHPWA-600 high performance water reducing agent is the third generation high performance water reducing agent,which is currently high-efficiency water-reducing agent with the highest scientific and technological content, the best application prospect and the best comprehensive performance in the world.
     It has the advantages of low dosage,high water reducing rate,good cement adaptability,small slump loss and strong durability,etc.  It is a non-toxic, non-corrosive, non-combustible safe high-performance water-reducing agent.
     Compared with the performance of similar products from China and abroad, XNHPWA-600 high-performance water reducing agent has reached the current international advanced level in terms of technical performance indicators and cost performance.
    XNHPWA-600高性能减水剂是第三代高性能减水剂,是目前世界上科技含量最高、应用前景最好、综合性能最优的一种高效减水剂。具有掺量低、减水率高、水泥适应性好、坍落度损失小、耐久性强等优点,是一种无毒、无腐蚀、不燃烧的安全环保型高性能减水剂。与国内外同类产品性能比较,XNHPWA-600高性能减水剂在技术性能指标、性价比方面都达到了当今国际先进水平。



Main performance  主要性能

Project

项  目

Performance

性能指标

Water reduction rate

减水率(%)
≥25

Bleeding rate ratio

 泌水率比(%)
≤60

Solid content

含固量(%)
≥15.0

Air content

含气量(%)
≤6.0

Density

密度(g/cm3)
1.04±0.02

Total alkali

总碱量(%)
≤10

Chloride ion content

氯离子含量(%)
≤0.1

PH value

PH值
6.0±2.0

Difference in solidification

time

凝结时间之差(min)

Initial

solidification

初凝
-90~+120

Final solidifica

终凝

1h change over time

1h经时变化量

Slump

坍落度/min
≤80

Air content

含气量/%

Compressive strength ratio

 抗压强度比(%)
1d≥170
3d≥160
7d≥150
28d≥140

Shrinkage ratio

收缩率比(%)
28d≤110

Relative durability(200 times)

相对耐久性(200次)(%)


Scope of application  适用范围

    XNHPWA-600 high-performance water reducing agent is suitable for configuring high, medium and low grade concrete, and also suitable for configuring various types of precast, pumping, long-distance transportation, self-flowing and other performance requirements. 
  XNHPWA-600高性能减水剂适用于配置高、中、低各类标号混凝土,也适宜配置各类预制、泵送、长距离运输,自流态等各种性能要求的混凝土。

 

Precautions for use 使用注意事项

1、The content of this product (solid content 20%) is 0.6% to 2.0% of the total weight of the cementitious material. The usual dosage is 0.8%~1.5%. Before use, a trial mix test of concrete should be carried out to find the best mixing amount.
   本产品(固含量20%)的掺量为胶凝材料总重量的0.6%~2.0%。常用掺量为0.8%~1.5%。使用前应进行混凝土试配试验,以求最佳掺量。

2、This product can be mixed directly with the cement into the mixer, or first add 40-70% concrete mixing water, and then add this product, the effect is better.
   本产品可随水泥加入搅拌机直接搅拌,或先加40~70%砼拌和水,再加入本品,效果更佳。

3、This product should not be mixed with other water reducing agents. Before using this product, the storage tanks, mixers and mixer trucks that have used other water reducing agents must be rinsed, otherwise the water reducing effect may be affected.
   本产品不得与其它减水剂混合使用。使用本产品前必须将使用过其它减水剂的储罐、搅拌机和搅拌车冲洗干净,否则有可能会影响减水效果。


4、When using this product, the measurement must be accurate and the concrete must be mixed evenly. Excessive addition of additives or uneven mixing may cause segregation of bleeding and difficulty in pumping.
   使用本产品时,必须计量准确,混凝土必须搅拌均匀。加入超量外加剂或搅拌不均匀可能导致离析泌水、泵送困难等现象。

5、Because this product has the characteristics of high water reduction rate, the slump is highly sensitive to water consumption, and water consumption must be strictly controlled when using it.
    由于本产品具有高减水率的特点,因此坍落度对用水量的敏感性较高,使用时必须严格控制用水量。


Packaging and storage 包装与贮存

1、This product is liquid and is packed in 1000kg plastic drums or plastic bags.
   本产品为液剂,采用1000kg塑料桶装或200±1kg塑料桶包装。

2、Should be placed in a cool, dry place, sealed storage away from direct sunlight, rain or negative temperature environment preservation.
   应置于阴凉、干燥处储存,避免阳光直射、雨淋或负温环境保存。

3、The warranty period is one year, and the overdue products can only be used after being tested and verified.
   质保期一年,超期产品经试验验证合格后仍可继续使用。